1999 Pontiac Montana "need location" Questions

Ad

Question about Pontiac Montana

1 Answer

i need to replace the fuel vapor pressure sensor in a 2000 pontiac montana where is the sensor located. In the rear ,in front of fuel tank Need an EVAP Diagram to locate it Have to get one from a ...

Ad

Question about Pontiac Montana

1 Answer

need to replace starter. Where is it located? The starter is located on the lower side of the motor. Disconnect negative battery cable. Raise and support vehicle. Remove flywheel cover (s). Disconnect

Ad

...need to know the location of the rear heater blower motor on a 2000 pontiac montana i got the same van ill take 600 -500$ [email protected] the location for the rear blower motor is in the driver ...

Question about Pontiac Montana

2 Answers

...side good luck pierre This is a fun fix. It is under the glove box. If I remember correctly you need a 1/4 socket for almost everything. I also found out the hard way that it is a whole lot

...excede the red line but then drop just as quickly back down to normal position. Does the thermostat need changing and where exactly is it located. I think I know but not 100% sure on this. Should be ...

Question about Pontiac Montana

1 Answer

service engine light keeps staying on need to know where the oxygen sensor is located. hi if your refering to the oxygen sensor that is also called the lambda sensor then this is located in the ...

...Go to Autozone and they will check your cars trouble codes for free and tell you what part you will need to replace. They are usually right 99% of the time.The crankshaft position sensor located ...

Question about Pontiac Montana

1 Answer

need to know how many sensor. is on my transmission.. 2003 Pontiac Montana v 6 .. can you show me picture where transmission control solenoid goes? There are 12 common sensors and 10 internal sensors.

Question about Pontiac Montana

2 Answers

...may need to replace resevoir Looking at the location, it should be by the thermostat housing.....this is a pic of what it looks like.....and you can sort of make out the thermostat housing area

Question about Pontiac Montana

1 Answer

need to separate the fuel lines on each end of the filter to release it. there will be clips on the ends of the filter that hold the fuel lines. be careful not to break these clips. it is very hard to

Not finding what you are looking for?
1999 Pontiac Montana Logo

728 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...