1998 Ford Explorer "rear upper intake vacuum ports" Questions

Ad

Question about Ford Explorer

1 Answer

...vacuum leaks, most likely around the upper intake manifold arear, look for vacuum hoses that have come off or a missing vacuum port block off cap at the rear of the engine drivers side, large

Ad

...rear of the upper intake manifold Vacuum hoses to both the front and rear of the manifold assembly Throttle body Throttle linkage to the upper intake Wiring to the upper intake components including ...

Ad

...upper left front. The vacuum to the brake booster goes in the lower middle at the rear. If you have a second vacuum pot on the rear on the choke side it needs vacuum from the front. The transmission ...

...rear of engine block. STEP2 Apply thread locking compound to manifold bolts. STEP 3 Install the manifold and tighten bolts to 35 ft-lbs, in proper sequence. STEP4 Install the distributor. ...

Question about Ford Explorer

1 Answer

...rear of the block. Extend the sealer approximately 1 / 2 -inch (13mm) onto the heads. Install the lower intake manifold. Apply sealer to the lower intake manifold bolts prior to installation. Install ...

...upper intake. These bolts are located in the right front and left rear corners of the lower intake manifold. This is why it is necessary to remove the upper before servicing the lower manifold. ...

...VACUUM IT IS SUPPLIED FROM PORT ON REAR OF UPPER INTAKE PLENUM TOWARDS PASSENGER SIDE SEVERAL VACUUM LINES CONNECT THERE ON A 3.8 V6 WHICH I ASSUME YOU HAVE HOPE THIS HELPS IF NOT CONTACT ME @ ...

Question about Ford Explorer

1 Answer

...after the air cleaner housing usually a 4 wire connector. map sensor is normally located on the rear of the upper intake manifold with 1 vacuum line going to it with 3 wire connector. Hope this

rear valve cover. Cover the the intake manifold to prevent the entrance of dirt or other foreign material. Remove the screws from the fuel tube clamp and fuel rail retaining bolts. Spread the retainer

...upper left port goes to the vacuum switch for the secondaries. The brake booster screws into the rear base of the carburator. The transmission kickdown plugs into a nipple on the rear of the intake ...

Not finding what you are looking for?
1998 Ford Explorer Logo

4,510 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

1999 Ford Explorer
1999 Ford Explorer

2,248 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2004 Ford Explorer
2004 Ford Explorer

1,513 Questions

2003 Ford Explorer
2003 Ford Explorer

1,369 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...