...rear brakes: (note, do not remove hub retaining nut for this procedure) 1. Raise and support vehicle 2. Release the parking brake 3. Remove wheel and tire 4. Disconnect wheel speed sensor wiring ...
...remove the axels to change the brake shoes on a 94 chev 1 ton? Yes, the axles have to come out, then the wheel bearings, and finally the drums will come off. Be careful when pulling the drums, pull ...
94 geo prism replace wheel bearing assy Rear are a HUB ASSEMBLY and replaces as a Unit. Same for the Front. Remove the Axle Nut, Remove the Brakes, Remove the 3 or 4 Bolts and the hub will come off.
...wheel seal, you must have exposed the rear Emergency brakes on the 1 side you replaced the wheel seal on. You should have observed the condition of the part. The other wheel may have the Emergency ...
...remove or re-install due to the auto 4wd hubs? I have removed, re-packed and replaced rear wheel bearings before, but never fronts or messed with 4wd hubs. No, but I would replace the rotors. Turning ...
Remove the two rear engine support nuts at the rear of the transmission support crossmember. While supporting the rear of the transmission support crossmember remove the two rear engine support bolts.
...rear case you most likely need a new gasket or rust has set in and there is a hole or even pin hole present but most likely gasket the censor is working telling you there is an issue that needs ...
...remove rear shoe hold-down spring and pin. Remove rear brake shoe and anchor spring, Fig. 7. On Land Cruiser models, remove front hold-down spring using a suitable tool, then disconnect the parking ...
446 questions posted
Usually answered in minutes!
1,072 Questions
1,150 Questions
968 Questions
1,003 Questions
917 Questions