1995 Ford Bronco "distributor wiring 351 windsor" Questions

...351 windsor turns over but will not start ignition control module checked out good installed new coil still no spark. The only wires to the distributor are spark plug wires. Help have you taken the ...

...351 windsor fuel injected firing order and distributor placement 1-5-4-2-6-3-7-8 1-2-3-4 cylinders are on the passenger side starting at the front and 5-6-7-8 cylinders are on the drivers side ...

...351 windsor. I recently replaced all the gaskets, flywheel, a new rotor and cap on the distributor, spark plug wires, and plugs, electronic control module, and now i am getting very weak spark and it ...

I need the wiring diagram for a 1978 351 windsor distributor I am trying to replace a marine distributor (2 wires) with an automotive distributor (3 wires). I have the diagram for the boat distributor

...351 Windsor brand new distributor coil is good module came on new distributor I need help ? Since the coil is getting power you need to get a spark tester or pull a cord of one spark plug and lay it ...

Distributor cap has 1 marked but it is not located in the position that the diagrams show number 1 should be. Is this a problem? Does anyone have a picture showing which wires go where? I assume its a

distributor rotor turns COUNTERCLOCKWISE The marked # 1 position on the distrubutor cap faces to the REAR and slightly towards the drivers side The engine cylinders / spark plug locations are numbered

...wiring harness below the distributor. Loosen the distributor hold down bolt located at the base of the distributor with a 13 mm distributor wrench. 5 Start the engine. Aim the timing light at the ...

...351 windsor. i am getting fire and gas all the way into the fuel rail but it will not start. If i spray gas into it it will run until the gas is gone. can it be the injectors? if so can they go bad ...

...351 windsor and what is the timing procedure after the distributor has been pulled out. number one is the right front. 1234, drivers side is 5678 If you pulled it out and didnt make a mark to get it ...