1987 Chevrolet S-10 Pickup "engine stalls" Questions

2000. What causes the engine to want to stall at low idle? When I push on the accelerator, the engine wants to stall. This is only after the vehicle was in some idle conditions such as in traffic ...

...stalls (left injector while looking into the engine compartment from the front of the vehicle). I replaced the fuel filter to ensure there was not fuel restriction. I also replaced the injector and ...

2001 chevy s10 loses power, will not stall, restart runs better. 4 cylinder engine runs well, starts losing power, will not increase running power even if floored. engine does not stall but until ...

stalls 1987 s10 Started out with the check engine light comming on. Replaced spark plugs, wires, distribtor cap, rotor button, and fuel filter. Now the truck wants to stall all the time. This normally

...stalls in traffic. no check engine light or abnormalities from any other gauges. usually stalls on the stop or go. Any ideas? first is the air filter clean,then check your egr valve ,then throttle ...

...engine surges warm and cold, stalls my son has a 91 s10 blazer, it started surging, cold and warm, idles up then down and stalls, then at times it ides fine, not often though, surges while driving ...

oil pressure high when engine cold. but fine when engine is warm whenever you start the car and it is cold, the oil pressure is really high and if you accelerate hard the car will stall. when the ...

...engine stumbles to the point that it nearly stalls. It doesn't sound like a spark click more like a vacuum switch of some sort. I did check the wires and while some were not fully seated the problem ...

engine stalled and won't start 1997 s10 2.2 5 speed stalled after taking off from red light and won't start.engine spins fast like a timing belt broke Has anyone checked the copression? What hs been ...

...engine stalls Its good when you first start driving it then when the engine heats up the pressure drops and the engine stalls. What is the problem? Possible warped cylinder head, or cyclinder head ...