2003 Chevrolet Silverado Ss "chevy truck 1500 volt" Questions

...chevy silverado 1500 4.8 4wd will not start I Replace the fuel pump, filter, plugs, wires, relays are good, fuses are good, (steal no start) but I ran a jumper wire to the new fuel pump it started up ...

...1500 with the temperature gage reading high. Changed the same thermostate and still had the problem. Took it to the dealership and found out there is a problem with the instrument cluster and Chevy ...

Chevy Silverado 1500. When I go to turn on the A/C or heater you can hear it turn on, but no air actually come out of the vents. I believe this is a Blower motor issue. I have checked all of the fuses

...chevy silverado 1500 v8 battery drain after sits for 1or2day new battery in it drive around all day come home doesnt charge enough to crank engine specially when weather is cold needs to be jump ...

...chevy 1500 pickup truck headlights just My 99' chevy 1500 pickup truck headlights just went out. Bulbs are good, fuses are good. What could it be? Could be a bad ground oh headlights or power not ...

...chevy 1500 p/u. Alternator only placing 12.5 1993 chevy 1500 p/u. 5.7 L TBI 8-cyl. Battery just replaced, load test good.Static, it is 12.2 volts. So is static test to positive on back of alternator ...

...chevy 1500 that has a new alternator and when u kill it, wont start with out boost. so i boost and start back and pull cable off battery and it dies wat could it be?? Ok, first, you need a new ...

1998 chevy silverado starter clicking and slow to start Most common reason for this is a failing battery-at rest the battery should read 12.5 volts, when you crank it it should not go below 11.8 volts

...Chevy 1500, 5.7 engine.. will not start..no fire at spark plug wire, 12 volts at ignition coil, 12 volts out to distributor, no spark at coil to distributor (center wire), all fuses look good, new ...

...chevy truck 1500 Should have said that in the first place. Use a test light and locate the wire that is hot on the ignition switch with the key off. (to avoid constant draw, turn the key to the "on ...