1989 Chevrolet C1500 "getting oil top 350 engine" Questions

...top center working clock wizeand out ,intake boltes45ftlbs again fromcenter working outleft side, right side,left, right 8 bolts one time only or u will distort gasket. oilpan from center alternate L ...

...top,,, now get the distributor and get the rotor button pointed strait at the number 1 spark plug hole,,,your oil pump rod slit will need to align to ,,, look in distributor hole and use long screw ...

that makes the knock get worse if not it may be the main bearings, try a thicker oil or oil additive .worst is you need to turn the crank and get new bearings . you rebuilt the top and not the bottom

oil pump shaft is slightly off. the easy way is to get the dist in where it should be (rotor wise) is have someone turn the engine over as you keep contstant pressure down on the dist. after 1/2 turn,

...top it's stopped up. Or you can have a compression leak to the coolant, ( headgasket failure a cracked head, intake manifold gasket failure) with the cap off and the raditor full and the engine ...

...oil is getting to the top of the motor. you can do this by looking into the valve cover from the oil filler or the vent. If your not getting oil to the top of the motor you need to replace the oil ...

...oil filter on an 2004 f-350 diesel engine? The filter should be in a round plastic canister just about in the top center of the engine, you may need to get a band type filter wrench to get it

...getting eaten up on 1987 gmc pickup truck with 350 engine. if 180 degrees off could this cause oil pressure to go low may have low oil pressure Check for play in distributor rotor shaft as they get ...

...oil and filter and run.???? you would not get sufficient water past the rings to cause what you describe there has be a fault in the assembly as the water is getting in past the water manifold into ...

...oil guage 1982 original 350 GMC gas engine converted to propane (sometime?) Try looking on top of the water pump. There should be a small hole about the size of a pencil eraser. I have had both ...