1988 Chevrolet C1500 "clutch pedal" Questions

clutch pedal. If I depress the pedal slightly while driving it will stop until I let the pedal back up. Did you change pilot bearing? Could also be in the trans. Does it make noise while moving clutch

...clutch pedal to ctutch cylinder come off clutch pedal to the foor Are you  the link rod fell out/came off that depresses the clutch master cylinder and that you just don't have a failed ...

...clutch pedal does not seem to work the clutch I don't know if you have hydraulic clutch cylinder but sounds like it may be bypassing or have air in system. Try bleeding system and checking for ...

...clutch pedal spring pedal is dead When the pedal refuses to return it is probably that there is no fluid in the resevoir due to the fact that it has all leaked out at the slave cylinder. Refil and ...

pedal after driving but you may be able to pump the clutch and it would work again for a few shifts, 3. Or if your engine has a lot of miles on it being a standard transmission it could have developed

clutch pedal, a bang or pop can be heard from outside the vehicle,and a "click" can be felt on the pedal with your foot. both the pop and the click happen at the same time, when clutch pedal

...clutch pedal used to be up higher then the brake pedal now it will only go up as high as the brake. i also replased the slave cylinder and a new clutch kit but i was having this problem be for i did ...

you bleed the system, just make sure that the fluid level in the Master cylinder doesn't go below the port at the bottom of the reservior. You should be able to cycle the clutch pedal 2 or 3 times

...(by me and a friend) but now it dosn't work. The fork moves about 1 to 1 1/2 inches and the clutch pedal goes right to the floor. It's not working, why? MikeT896 The clutch system has air in

...clutch pedal far enough to start the engine I am too close to the steering wheel, and vice verse. Can the pedal height be adjusted? You can buy extensions for that. I don't know where but check ...