...side parking light? Directly below headlight. 2004 chevy tahoe. you need to pull the pins holding in the headlight. push them out of the clip and then pull up once both are removed the headlight will ...
...drivers' eyes. When you think it is right, park at night where you can walk in front of the car 100 feet or so and see that the low beams are not too high. The driver side light should point straight ...
Question about Chevrolet Tahoe
light reduced power on.Changed battery nada Do you know anything about automotive electrical testing ? Do you know what it takes for your vehicle to start ? When you trun the key to start what happens
Question about Cars & Trucks
...side rear driving light doesn't come on. Blinker & Brake lights work. I have a 2006 Silverado that rear lamps have recently quit working. A turn lamp and backup lamp on opposing sides. One was from ...
Question about Chevrolet Tahoe
...side, not hard, but the park.signal light comes on. The problem is is does not blink like it is suppose too. On the dask board the light is blinking really fast, but the passenger park/signal blink ...
Question about Chevrolet Tahoe
...side circuit board and parking light switch and all fuses are O.K. I even changed them just to make sure. Whenever I hit the brake pedal with blinker on it blinks really fast. that sounds like a ...
Question about Chevrolet Tahoe
...drivers front fender well... check for power at fuse/relay (pull the fuse out connect your test light to a ground - one side of the fuse socket should have power (with light switch on) if it doent it ...
...drivers side. I believe there may be a timer on the parking lights that turn them off after several seconds after the door is closed, this may be at fault if not the pin switch. newer cars and trucks ...
Question about Chevrolet Tahoe
...side parking light don't illuminate also the oil pressure gauge rises when I accelerate and dropes when braking any idea The parking light, check the bulb and the ground..and the supply wire. You can ...
drivers side door. Usually this occurs at the flex point of the wiring harness. Peel back the outer covering carefully exposing the wires inside. Repair any broken or those about to break. Solder &
1,468 questions posted
Usually answered in minutes!
904 Questions
942 Questions
830 Questions
647 Questions
668 Questions