1991 Chevrolet Cavalier "location oil pressure sending" Questions

...aftr i filled it up wth oil see if the oil is leaking from the pressure sending unit , usually located near the oil filter , if so replace the sending unit, if not have the pressure checked at a

oil pressure goes right down to 0 and my "CHECK GAUGES" light comes on when i hit the gas it goes off. it also twitches sometimes when im sitting at a light but my cavalier runs fine........

...oil pressure Gage put on the car to be sure the pressure is in spec, im sure it is fine if your motor is still running. but sometimes motors can develop low oil pressure, most likely your problem is ...

where is the sending unit on a 2.2L engine OIL PRESSURE SENDING UNIT LOCATED ON FRONT LEFT SIDE OF THE ENGINE NEXT TO OIL FILTER.

...with a 2.2L 4-cylinder engine is located on the front of the engine just above the starter near the oil pressure sending unit. The location of the crank position sensor is near the oil filter

...oil pressure if this is didnot pass then you have an internal eng problem You need to have someone check the actual oil pressure with an external mechanical gauge. though your problem may just be a ...

...oil pressure with a mechanical oil pressure gauge.  I suspect you will find that at idle it is virtually nil, and probably not much better at speed.  There are two probable causes of this, ...

oil leak areas ....then run the engine. Check for the start location of the leak. Start with a short run time ....... then longer run time if necessary until the leak(s) show. With or with out the dye

...oil pressure sending unit...located by the oil filter...it has a wire connector plug in...you need a special socket to remove, and replace...Your parts store can show you the part before you buy ...

...location on the head. If you have access to  a heat gun it might be a good idea to check out the actual temperature, but it probably won't hurt to change the sensor.The other problem that ...