2001 Pontiac Grand Prix "replace window motor without taking" Questions

...motor to the regulator, and they just get eaten up over time. i have in the past replaced those teflons balls with ball bearings of the same size without any more trouble. those windows are hard to ...

...window regulator in a vise(very important) get a drill bit large enough to drill off the 4 giant ribbits.you can replace the ribbits with small screws,most of the time they come with the new motor. ...

replace the serpentine belt for power window on 2003 dodge durango The motor works on the driver side window but the belt comes off. Can I just replace the serpentine belt without replacing both motor

...window would not go back up. from driver door panel all other windows work. Motor bad or switch. Cannot get into control box without distroying control knob I looked at the wiring and I think the ...

...window motor, but cannot get the motor off. Do I have to take the regulator out as well, or is it possible to replace the motor without removing the regulator? if it is the same as my 1996 ford you ...

...window wiper shaft on the 2005 expedition, lubricate or replace and how to put it back together without breaking the rear window by prying or overtightning the bolts???? ( I can't figure out how to ...

...window up by hand, but it won't stay there and will move down back due to gravity but all the way to the bottom. When I pull the switch, I can hear the motor rolling. I have taken the panel off. ...

...window motor, with "PB Blaster", then while pushing window switch up and down, tap the motor lightly with a hammer. Do this to the switches too. the PB Blaster gets inside and cleans the contacts of ...

window motor.My best advise is goes the easiest, cheapest route.  Replace the swithch first.  That way if it solves the problem, you only have a couple of bucks into the repair, and you didn

window up without the motor you will have to take the door panel apart. You will have to take the motor out of the loop to move the mechanism, raise the window and put the locked motor back in to hold