2001 Chevrolet Venture "causes knocking water pipes" Questions

...knocking sensor? any solution? [email protected] please write me if you have any solutions. best regards Nas Look at your coil, this sounds like it is electrical in nature. Water on a coil will ...

...water smell out of the pipe at idle. I have Honda 2003..last day while I'm driving my car it's knocking.but after some times it's happened that gear was not shifting..thn few times later car stuck ...

...knocking noise coming from engine Sounds like a blocked catalytic converter. Go to the back of the car and place your hand by the exhaust pipe and feel for exhaust flow. Have a helper accelerate ...

2001 Passat 1.8 Turbo engine sputtering and hesitating Whenever I put the passat in reverse or drive it starts to shake, which is not normal or it. I took it to a mechanic who used the X431 diagnostic

...knocking noises. Correct piston to sleeve clearance. The shim to cam clearance is to spec, there is sufficient compression 10.5:1 there is spark, it starts first time, it idles perfect and smoothly, ...

...water pump stops turning the engine can no longer be cooled. If this happened then there's a good chance that the heads were warped. This would cause the loss of power and the knocking. This does not ...

What does it mean when check engine light is flashing and white smoke coming out of exhaust pipe along with raw fuel? 2003 Chevy Tracker Check Engine Light Flashing, Thick White Smoke Coming from ...

2006 dodge charger 2.7 v6 over heating is there any solutions ? 2006 dodge charger 2.7 v6 over heating did flush changed thermostat and water pump and fans working anybody know what to do it's not ...

...water by-pass hoses from the throttle body. Disconnect the 2 wire clamps from the wire clamp bracket on the RH delivery pipe. Remove the bolt and nut holding the engine wire protector from the intake ...

knocking from the engine), pulled over and let her cool down. drove home at very moderate speeds, non-highway, kept revs under 2000 rpm, ran the heater on high. the temp would drop to about 3/8 on the