1988 Mazda MX-6 "3 positive cables" Questions

Ad

Question about Mazda MX-6

1 Answer

...3 times on and off within 5 seconds of eachother as in (on off, on off, on off) turn the key on sit for 10 seconds then try to start it, this is how you reset the computer.. if this dont work one of ...

Ad

...3 bolts holding the starter in place ,you can get 2 bolts from the drivers side and one on the bottom. It located under the manifold connected to the transmission,the positive terminal of battery is ...

Ad

...3 out???? Hi If you have a new battery and it dies it means that the alternator is bad. The alternator is what replentishes the battery and run the car while you drive it. A simple test is as follows ...

Question about Mazda MX-6

7 Answers

...cables and connections; 2. charge the battery if required; 3. clean brushes and guides of brush holders of the starter motor; 4. clean the commutator and commutator segments; 5. check/replace the ...

Question about Mazda MX-6

1 Answer

...at the bottom left or right of the rad. If it is less than 1-2 years old save and reuse it. 3.remove any parts that may be in the way of removing the rad and fan. 4.disconnect the coolant ...

...shoes and linings: 1) position the rear brake shoes and linings 2) position the parking brake lever 3) install the brake shoe hold-down spring pins and the brake shoe hold-down springs. Install the ...

...positive battery cable on first-dont tighten up yet 3-put negative battery cable on battery dont tighten yet 4-wait 2-minutes 5-take positive cable end off,ho;d in hand 5-take negative cable end off ...

...REMOVAL 1. Remove air cleaner and air intake hose assembly. 2. Remove center dash trim panel. 3. Remove center console cup holder assembly. 4. Remove floor console assembly. 5. Remove console ...

Question about Mazda MX-6

1 Answer

...positive cable, but buy the one specifically designed for your car. If Nissan is too expensive, buy a generic one that is the same length with the same connectors at each end. Doesn't have to be ...

Question about Mazda MX-6

1 Answer

...casing and appears cannot be disabled completedly without pulling other parts out. there should be 3 cables feeding into the positive terminal. bull all three and inser them into your new

Not finding what you are looking for?
Cars & Trucks Logo

44 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1993 Mazda MX-6
1993 Mazda MX-6

132 Questions

1994 Mazda MX-6
1994 Mazda MX-6

87 Questions

1995 Mazda MX-6
1995 Mazda MX-6

81 Questions

1996 Mazda MX-6
1996 Mazda MX-6

59 Questions

1990 Mazda MX-6
1990 Mazda MX-6

40 Questions

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...