1999 GMC Jimmy "oil gauge goes 50 psi" Questions

...oil changes? If not the problem could be sludge build up. The oil pressure sending unit could be the problem. If in question about the sending unit install a mechanical gauge and watch the

...oil pressure gauge just jumped to high. I turned the motor off and turned the key on without starting the motor and it went to normal. Soon as I starred the motor, it jumped right back to high. What ...

oil pressure gauge goes up when car started, but then down to 0 I have 1997 Jeep Wrangler, the oil pressure gauge goes up when the car is started and then drops to zero and the CHECK GAUGES light ...

...oil pressure gauge and info center tell's me low oil pressure for 3-5 seconds then the pressure comes up but not all the way after about 8-10 miles it the pressure has been going to about 35 psi and ...

...oil pressure gauge to see what you have for oil pressure. Your problem might be as simple as a bad oil sending unit. Crankshaft - cam bearings ,could be ! Did you check the oil pressure sender ? Pull ...

...oil pressure gauge is showing 73psi at idle and as I drive it goes up to 90psi under 2oooRPM.. both the computer and gauge read the same psi.. Can I drive like this? What is the solution? That is ...

...oil pressure sensor and install a mechanical gauge 0-120 psi long enough so you can check from the driver seat. 2.- Start engine and check the oil pressure. the pressure must be between 35- to 70 psi ...

...Oil pressure will increase slightly with RPMs, I wouldn't think it would go too far over the middle mark on the gauge. If it's an actual measurement that's numbered I would think 50 to 60 PSI at ...

...goes to 110+ PSI. We don't have leaks... Please HELP ASAP. Compressor spins, have jumpered to ensure on relay. whenever the ac system has been opened it should be hooked up to a vacuum pump designed ...