Question about Nissan Altima
front driver side changed brake pads,caliper caliper bracket pins and clips.help changed all and still have popping noise you can also fill it in the brake padel when you apply the brakes. thanks that
Question about Nissan Altima
...FRONT PASSENGER SIDE OF CAR... NOT RELATED TO ENGINE REVS.... CHANGES WHEN LASY TURNS ARE BEING MADE AT HWY SPEEDS..... BUT NO WOBBLING OR UNUSUAL VIBRATION FELT IN STEEREING CV joint has gotten ...
...front wheels. Loosen to bolt on the bottom of struts (Its a bolt and nut). Remove clip that holds brake hose on to strut and remove hose. DO NOT OPEN BRAKE LINE OR DISCONNECT FROM CALIPER. Remove ...
2008 ford f150 front rotor/hub assembley want to change front rotor/hub assembly in two parts Here's a link on your front wheels assembly. 2wd front hub rotor change 04 08 F150online Forums
...front wheels so i can turn them and slowly move the hub where you can fit teh stud in and use an open lugnut to tighten down it will pull the stud in (i use an air compressor for this) it is a whole ...
front wheel bearing,So it's easier to change bering and hub assembly before changing the hub check the abs connection-- the sensor wire connection clips onto the spindle-- a lot of times the connector
...front hub that I can change the wheel bearing when they're bad. buy an older truck to answer question all newer model vehicles have gone to a hub/flange bearing assembly these bearing setups handle ...
Question about Nissan Altima
...changing the hub assembly when trying to pull it I pulled the front half of the hub assembly off and left the bearings in the hole what do I do? Wish I could figure out how to upload a picture but I ...
changing front brake rotor on 1995 honda passport Put the parking brake On and jack up the front of your SUV. Remove the lug nuts and you will be able to remove the tire and rimm by sliding them ...
...front hub and bearing assembly on 2004 Explorer Front hub bearing, remove tire, remove caliper and caliper holding bracket, you do not have to remove brake caliper from brake hose, just set it aside, ...
542 questions posted
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,306 Questions
569 Questions
534 Questions