1995 Nissan Pathfinder "loosen torque bit head bolt" Questions

...loosen something else. Bit more difficult. On my old Mazda this was loosening the bearing. Beware of contamination and re-adjusting bearing play and right amount of torque to be applied. Once you get ...

...torque wrench. Remember, work in a spiral pattern to get the head to seal evenly. -have new head bolts. -lube bolts and finger tighten -start in the middle and work your way out one side to the ...

...Torque... (Could not possibly hurt... unless you do it wrong!) Just not sure of the "OVERHEAT" diagnosis... sounds more than a bit odd. *** If there is any previous history of overheating... I would ...

...to 75 Nm (54 ft.lbs.). (5) Loosen the bolts completely. (6) Torque the bolts to 20 Nm (14.5 -ft.lbs.) (7) Tighten the bolts l/4 turns (90?) more. (8) Tighten the bolts l/4 turns (90?)

...bit would fit, however, there is simply a round hole with threads. Any suggestions? Find the appropriate socket for the bolt along the tensioner pulley and attach it to the 3/8-inch ratchet handle. ...

torque specs for starter refeer to manual or call delearship they will be glad to tell you specs for free,once you have starter in connect battery,then start car,if starter is noisy when starting then

torque wrench with a 1/2 in dr. to remove the knuckle bolts. I should've taken pictures, but I did not. After studying this exact issue for an hour or so, I finally got everything to click. Steps as I

...torque the bolts evenly to just snug.a good idea is to replace the thermostat as well at the time you are doing the water pump. After you refill the radiator, pump the bottom rad hose with your hand ...

...bit of twisting and turning. Also, unclip the flexible shielded bundle of cables from the crossmember. then disconnect the larger orange/+ battery cables and the purple command wire from the starter ...

loosen the top 2 bolts on the motor mount a little, about 2 centimeters (cm) each. The motor will pull down on the mount and begin to separate. Don't worry, the bolts are pretty long. There is a point