1988 Nissan King Cab "pajero cylinder head replacement" Questions

...Pajero! I had full compression on all cylinders but would Not run! I made further investigations and found the Cam Carrier/s were ripped out of the cylinder head. I helicoiled them and Bingo instant ...

Pajero v78 overheated and can't drive more than 10 miles every time. if I removed thermostat and drive, it can go up to about 40 miles. What should i do? you have blown a cylinder head gasket,

cylinder head and gasket on my 1995 2.8 turbo pajero and now its not turning over. All i get is a clicking/ticking noise when i attempt to start it, i think i need to reset the timing?? How do i check

...pajero it has a lot of problems about heat first you have to check if it loose water with pressure the system. Second you have to check thermostat third you have to check timing belt .4-you have to ...

...pajero 2006 there is a coolant leak how to check the cooling system and replace system integrity is normally done via a pressure test with a cooling system tool that is used to pump the system up to ...

...pajero iwas driving home when temp gauge shot up and the engine died i refilled radiator the car kicks over but will not start Your coolant all leaked out, or your thermostat locked shut, and the ...

...pajero I have had cylinder head done new water pump thermostat and replaced radiator Could be a few things - thermostat stuck shut? Hole in radiator? cap not sealing? Blockage in block/hoses? Water ...

...cylinder head on my pajero 2.8 diesel. It started first time and ran for about 4/5 mins then cut out. It is attempting to fire but won't.....any ideas would be grate Head gasket replaced. Ran for ...

Pajero (montero) it has a rough idle when hot have replaced the Idle Stepper Motor Spark Plugs but the problem still persists any answers? check the engine breather pipe and make sure its not perished

Pajero i0. Looks like it ran without oil and the valves bent somehow. Out another cylinder head and the thing won't start. Opened the in tank fuel pump and pressure seems low. I have a 0.3 kpa reading