2005 Chevrolet Uplander "not crank" Questions

...crank it a lot to start it. Not sure if others have the same problem, not may car just researching the problems. No codes set in the computer. Ignition module changed out. Problem still there. check ...

...to start my 05ChevyUplander it turns over but will not crank, take key out and it keeps spinning for about five seconds. Can anyone help me? Replace the ignition switch to start with. Defineutly

...crank my car this morning and it will not turn over. i have tried jumping it off and nothing so i think the starter has went out IT SOUNDS LIKE STARTER BUT MAKE SURE YOU BATTERY POST ARE CLEAN , IF ...

!!!!! Make sure all the cables are connected to the battery correctly. Also make sure that their is not corrosion around the battery posts

...the fault codes have been sorted out you need to clear codes. These 02 sensor codes may not be related to your "no start when engine hot" problems but you have to start

...crank but can not take out of park drove car for 6 hour/ made it to destination/ placed in park and turn car off/ got back in car / craked up but would not come out of park the brake pedal controls a ...

...not fall off. Crank the cable clockwise to raise the wheel. It will get hard to turn when the wheel is all the way up. The space saver spare is stored under the vehicle with the air stem pointed down ...

crank sensor on a Chevrolet uplander 2006 you can clear the trouble code with the obd2 scanner then, if the code comes back, you'll have to deal with changing the sensor, or tracing the wiring to make

...very simular. 1) Locate and remove any, and all screws from the panel(if any, some door panels do not have screws). 2) After removing all screw's, you will want to disingage all of the pop clip's ...

...Not counting the temp gage,any signs of overheating? Sometimes when you open the cooling system, you get air in the system that can effect temp gage. You could use a non-contact infrared temp gun on ...