2002 Chevrolet Malibu "remove rear control arm" Questions

control arm back in place, because the rear vertical bushing was hard to reinsert back in it's slot, ... One advice though.....take the brake disk out before putting the control arm back in place...it

...rear passenger side window that is stuck and will not roll back up The window rolled down, but will not come back up. It sounds like the window's motor is still working, as when the button is pressed ...

...Remove the lower control arm rear bushing retainer bolts located on each side of each lower control arm rear bushing. NOTE: The bolts fastening the cradle crossmember reinforcement are of three ...

rear wheels. Remove the 2 nuts and left stabilizer bar link. If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud. Repeat for the right side. Remove the 8 bolts,

...to help my lower control arm be removed safely. I'm not sure that my rear lower control arm is under presser. if the shock isn't connected directly to the control arm no need to do anything with ...

rear bottom control arms. There are brackets on the stock control arms holding on the e-bake line, remove them first with a 13mm socket. Now you can remove a bottom control arm held in by 2 bolts with

...bolts .then remove suspension arm bracket nut .remove suspension arm bracket bolts. remove rear bracket and suspension arm. torque ball stud nut 44 ft lbs torque suspension arm rear bolts 32 ft

...rear lower control arm, remove the 2 bolts holding the arm in place and install the new control arm. An alignment is recommended when changing any part of the suspension, especially control arms, tie ...

...remove rear crossmember to body bolt and remove control arm.torque control arm to crossmember nut and bolt 81 ft lbs, torque ball joint to steering knuckle bolt nut 44 ft lbs.torque crossmember to ...

...Rear) in Brakes. Remove the brake rotor. Refer to Brake Rotor Replacement in Disc Brakes. Remove the ABS sensor wire connector. Remove the four bolts from the control arm. Remove the hub and bearing ...