1998 Chevrolet K1500 "chevy truck trouble code" Questions

chevy truck k1500 4.3 runs bad I have a 1998 chevy cheyenne k1500 4.3 manual trans. Service engine soon light on, code for maf sensor, replaced, 2 oxygen sensors codes on replaced front one, truck ...

...chevy cheyenne p/u with 4.3 engine 1500 series. Trouble code 12. Won't idle code 12 is always present in gm motor products. it simply means no tach signal because engine is not running. i would go ...

I have a 1993 Chevy Silverado 1500. trouble codes 22, 35, & 37. what do they mean? code 22 throttle position sensor low voltagecode 35 EGRcode 37 doesnt exist but im getting a code 37 also

...that would cause my truck to stall after warm-up, again I own a 1994 chevy K 1500 with the 5.7 engine Here's a link on how to replace,if it doesn't fix,take back for refund.Here's what it look's

...Chevy pick up with a PO449 code, I checked the voltage @ the solinoid and I have a key on positive and no ground from the computer, I also tested the wires to make sure the plug was good. this is an ...

...chevy suburban 5.7 liter will not idle it will run smooth if throttle is held down a little but when put in gear ir dies has no trouble codes. will not stay running at all if you dont hold down on ...

...truck! Bank one misfires under a load. Removed cats, new plugs and wires, fuel pressure at rail is great. Whats the f@%#$n problem? I got no trouble codes! its a mystery! 2005 chevy silverado you ...

TRUCK IS A 1997 CHEVY K1500 WITH 61000 MILES AND APPEARS TO BE RUNNING FINE.NO APPARENT TROUBLE NOTED. If i is running fine then it wouldn't be anything inportant.I have a 91 chev and the engine light

...Chevy k1500 has the rpms but won't do over 35mph an boggs down an dies what could it be The generic info for problems at higher rpms, check for a blockage of some kind, fuel--air--exhaust. How long ...

...chevy silverado 1500 single cab. 180K miles. Last few days if the truck sits for 8 hours truck has a hard time starting up. Takes a good push on the gas to get running. Oil changes and fuel injection ...