2003 Nissan Maxima "camshaft sensor 03" Questions

Question about Nissan Maxima

03 Maxima SE... Check engine light is on and getting codes P0011 AND P0021 which is the intake camshaft position timing over. I also have P0462 because my fuel level sensor always reads as full and wh

...camshaft position timing over. I also have P0462 because my fuel level sensor always reads as full and while driving drops to 1/4 level then back to full... What are some possible solutions and ...

Question about Nissan Maxima

2 Answers

Getting code poo11 on a

...Camshaft position sensor Tech notes Since the Intake valve timing control solenoid valve uses oil flow to control timing, dirty oil can cause the valve to stuck open or close. Before replacing the ...

Question about Nissan Maxima

1 Answer

Is there a fuse or

...or a relay for a camshaft sensor on a 03 impala 3.4 litre CAMSHAFT SENSOR GET IT POWER FROM THE PCM.THE CAMSHAFT SENSOR IS A HALL EFFECT DEVICE TRIGGERED BY A MAGNET ON THE CAMSHAFT.IT DONT HAVE

Question about Cars & Trucks

1 Answer

Lincoln Ls v8 camshaft sensor fix

...camshaft sensor fix What difference (if any) is there between a CAMshaft sensor and a CRANKshaft sensor? I have an 03 Lincoln LS v8 that may need one or the other. Not sure and dont want to replace ...

Question about Mitsubishi Cars & Trucks

1 Answer

Where to find the location of the camshaft position sensor for a 2003 mitsubishi galant v6 3.0

camshaft position sensor for a 2003 mitsubishi galant v6 3.0 See the videos P0340 Code: Camshaft Position Sensor on Mitsubishi Galant Code ... https://www.youtube.com/watch?v=37UszfOKGNg ? 5:47 Oct 14

Question about Nissan Maxima

2 Answers

Where is the camshaft position sensor at on a 1996

...camshaft position sensor at on a 1996 Ford f150? Section 03-14: Engine Controls, Electronic 1996 F-150, F-250, F-350, F-Super Duty Series and Bronco Vehicles Workshop Manual REMOVAL AND INSTALLATION ...

Question about Nissan Maxima

1 Answer

Troubleshoot crank position sensor location

...Camshaft position sensor and Crankshaft Position Sensor? http://technoanswers.blogspot.in/2012/06/2005-dodge-durango-replace-camshaft.html ---------- GMC Crankshaft Position (CKP) Sensor Replacing? ...

Question about Nissan Maxima

1 Answer

Cam shaft sensor bank 1

...camshaft sensor is shot. I had the same problem on my 03 coupe. There are two camshaft sensors. They are located on the back side of each cylinder head. My 1st one went out and I replaced it and then ...

Question about Saturn Cars & Trucks

1 Answer

I have a l200 saturn 03 was running with old coil and boots but was misfiring. Replaced coil and boots now wont start will roll over but wont start if does start dies within 1 min. plugged computer in

camshaft sensor but 03 dors not have camshaft sensor. Whats my problem gives cod p0340 The 2003 Saturn L200 does have a camshaft position sensor. It is located on the bottom front of the engine behind

Question about Nissan Maxima

1 Answer

03 Taurus with DTC P0340, P1336

...the Camshaft Position Sensor.I looked up the codes and they say pretty much the samething. P0340FordCamshaft Position Sensor Circuit Malfunction P1336FordCrankshaft/Camshaft Sensor ...