1988 Buick Regal "tools need remove control arm" Questions

...need a strut compressor in order to complete this task No you don't. When you buy the parts there should be a bolt in each box. With the tires on the ground. Look at the lower control arms with a ...

...need to get from you auto parts retailer. you can usually rent these tools. Turn the control arm over in the arbor press, then position the arm so that it is supported by the receiver tool MB-990799 ...

...tools available from online tool shops. A 1/2" drive breaker bar is attached on top of the tool while an allen wrench seen in the middle counter acts the by holding the strut in place. Tool without ...

...need place jackstands under the frame and lower vechicle so the weight of the vechicle rests on the jackstands and not on the control arms, then remove the front wheel remove ball joint and nut, ...

...separated from the power steering control valve if you talking about removing pitman arm.you need a pitman arm tool J - 6632 or equivalent.the auto parts store should have one or snap on

control arms and doing the bushings. You'll need a tool to Disconnect the ball joint and you'll also need an alignment. Installing the new bushings don't seem to require a tool. Parts seem to be about

...tools..remove wheel, remove axle nut, remove brake caliper, remove lower control arm bolts,remove the bolt for upper control arm, remove the outer tie rod bolt, support vehicle and suspension, the ...

...tools? You need air tools, many differnet size sockets and a press. The strut/spindle and lower control arm have to come out all together. leaving the axle in the car.The spinlde cannot be removed ...

...tools may be needed to remove the ball joint from the arm, and possible damage to the control arm can occur, The better process is to replace the control arm assembly. Make sure to have alignment ...

...need to get it out so i can finish rebuilding it. so please help?!?!? You're not supposed to replace the uppers on a 98 ranger. They're not meant to be pressed out because its built in with the ...