...sensor . Is there a special tool? I can get a wrench back there but can't enough leverage on it to remove. Ideas? Yes, there is a special socket to fit the O2. You need to see if a short one or long ...
Sensor Wrench & a good quality22mm wrench, to remove itYou will have to wear gloves & hit your ratchet or wrenchor use a soft mallet to break it looseThen work it back & forth so as not to
...thread and it comes with an o ring and a u shaped clip please someone help me That's correct, the old vehicles have a screw on sensor. Always replace with new o-rings if not included with the sensor. ...
...sensor I'd tried everything. I don't have any power tools Have you tried putting the screwdriver or torx bit into the screw and lightly tapping on it to break the corrosion on the screw ...
...sensor, an extension, and a socket wrench and just pray to God that that thing will turn. After cursing at it for a solid hour it will eventually break free and you'll be able to turn it about 5 ...
...plastic gear inside the latch drive unit. For details on how to fix the drive unit, check out this thread:
...sensor locations break down like this. The bank refers to which side of the motor. Bank 1 is always the same side of the motor as cylinder number 1. Bank 2 is the other side of the motor. Sensor ...
...sensor is on the exhaust manifold under the vehicle. Single wire with a plug. Unplug it, unscrew it reverse procedure. If you cannot break it loose use a little heat carefully from a torch.When you ...
sensor located on umy 2000 town car? A dual exhaust system has 4 Oxygen (o2) sensors. A single exhaust system has 3. As the diagram shows, your #1 sensors are towards the front of the vehicle threaded
...break the tap. If that doesnt work then you use to be able to get thread inserts (use to get them for stripped out spark plugs) but I dont know if you still can. You could always try a scrap yard ...
725 questions posted
Usually answered in minutes!
757 Questions
631 Questions
420 Questions
426 Questions
352 Questions