1998 Chevrolet S-10 Pickup "put timing chain olds" Questions

put the new parts in and set the timing marks in accordance with the manual. if the engine is interference type, you probably are going to need new valves and a used engine with lower miles would make

...timing is set to 8 degrees at 700 rpm...if it helps any Are you putting in a new timming chain? If so it should have came with a new crank gear witch has the mark on it, it will be on one of the the ...

...timing chain, #2 fuel injector, plug wires, throttle pos sensor, crank sensor, o2 sensor, and 1of the 2 coils. it ran fine. for a week or so. i went to start it one morning and it acted like the ...

...put on a new timing chain then when done it willnot start i think it fired a few times. MAYBE the cam sensor was defective the place i got the chain set said some people complained theirs did not ...

timing chain and gears good help Hi there. Sounds like the chain jumped a couple of teeth putting the valve timing out. Check timing marks on crank and cam. Check for slop in chain. If sloppy, replace

...put on Google Chilton and the car model to find sellers, or go to Haynes. Check also the links below: GM Timing Belt & Timing Chain Replacement Timing Chain Install Help. Discussion: How to Install ...

...engine. DO NOT be tempted to just put in a new chain, replace the chain and cam gear as a set, wear on the cam gear will cause the chain to be slack, which in turn causes the cam timing to be

...put a double roller timing chain so the crank sencer I shim it out so it wouldn't rub on the timing chain now the sencer sits more on one side of the postioning part of the sencer is this a problem ...

...put new timing chain & gears in but cant get it timed right 5.2 no start problem he changed wires cap & rotor checked firing order OK so figured it was timing chain changed chain & gears ...

...timing mark , Ifind it easy to put thumb over spark plug hole and have someone bump the engine over and feel the pressure relief stop before you feel vacumm - timing mark should line up if the timing ...