1998 Chevrolet S-10 Pickup "distributor install problems" Questions

Ad

...sensor problem - why would this come up now and what can I do to fix it I would verify that the distributor is in time. I had a customer with a similar problem, check engine light, and running ...

Ad

Question about Chevrolet S 10

2 Answers

...distributor wont go down aldaway down,i got truck on tdc but still doing something wrong,thank you make sure cylinder #1 is top dead center. Install your dist so that the rotor is pointing straight ...

Ad

...install, does it just pop out? not sure if its the problem,starts and idles fine, push on the gas and it starts to rev than cuts out, bogs down, let go of the gas and goes right back to a good idle. ...

Question about Chevrolet S 10

1 Answer

...install this My speedometer gauge go all the way to 100mill and the RPM's go up and down. the motor almost stop and then go up again. the first 10 seconds I can hear more air flow in an afther that ...

Question about Chevrolet S 10

1 Answer

...install a new dist. and noticed that the new dist had a wire coming from the top part that I dont know were it plugs into, the modual is plugged in. I'm thinking that possibly that two prong plug is ...

Question about Chevrolet S 10

1 Answer

1983 S10 running rough 1983 S10 2.8 V6 running rough, new plugs, new wires, new distributor, timing set, new Transmission installed. How do I fix this problem? The main problem is that you have ...

Question about Chevrolet S 10

1 Answer

...misfire of engine after replacing plugs and wires I did this also recently, but I also changed the distributor cap and rotor. THAT was my problem....Distributor screw tabs on distributor are plastic ...

Question about Chevrolet S 10

2 Answers

...distributor as since it warms up it runs fine. Hope this helped Tim there is a check valve incorporated in the fuel pump that often fails, allowing the fuel in the lines to drain back to the tank. ...

...3 cylinders. I've seen them run on 4& 5 cylinders, so I know the difference. I installed a new distributor cap and rotor as the other one was extremely oxidized and corroded. When completed, ...

Question about Chevrolet S 10

1 Answer

distributor install etc. Problem starting may be due to improper setup or a mistake or previous problem that existed before you did whatever you did to the engine, so go over everything carefully. I'm

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

2,062 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...