2000 Buick Century "ignition relay fuse" Questions

metal when removing it the car shut off and now wont start .......checked all fuses inside and out ...relay and inline fuse all seemed fne chances are good u blew the ignition module, coil pack or ecm

will not start, no gas in rail, but when jumped from the starter wire, turns over but will not start. check the ignition fuse and relay condition

...ignition switch to run (idiot lamps will light) and see if the fan starts. You have just tested the motor, wiring, relay and fuse electrically. Start the car and see if it overheats and turn your ...

ignition switch to the Start position sends a 12 volt signal through the Crank Signal BCM, Cluster fuse in the Fuse Block - I/P to the BCM, IPC, and PCM to notify these modules that a crank status has

...ignition point The keys may be code protected Check whether your security system is still active even if the doors are open!! Try to click the the unlock\ lock button simultaneously, when the doors ...

...can you hear it run when you turn the ignition to on position, if not chk. fuse and relay and all electrical connections and grounds, If it does run get a fuel pressure guage and chk. the

relay may be faulty, or the fuel filter may be plugged. If there is no spark, then crankshaft position sensor, or ignition module which is what the coil packs and plug wires are attached to may be bad

...relay and swap it with another one and see if the starter works. If that didn't make any difference, try this:Make sure the transmission is in park, emergency brake on. Turn the ignition key on. Find ...

...for a tempory fix until i can get in in the shop in a few days remove ignition fuse/relay (in engine compartment box) and then remove negative battery cable from battery (to prevent battery

Car not getting spark to spark plugs. Have checked all 3 coils, replaced ignition module and battery chec fuses then inspec maxifuses and relays in engine area--some may appear good-so testum--look ...