Question about Mitsubishi Lancer Evolution
torque settings for 1993 Mitsubishi Lancer Evo 1 what do you need to torque
2006 Lancer Evo 9 grinds when shifting into 5th no matter how hard of soft you shift. 1-4 shifts great... Syncros need to be replaced, Its almost better and worth the little extra to spend to replace ...
...change a cambelt on an evo 6 u need to get the cama set right and engine locked u really need some 1 that knows what doing alot aof money if udo it wrong or u can try evo lancer ...
...when putting your foot down, revs seem to go high but there is no real response with the boost. 1 garage seems to think its electrical and another thinks it may be the torque converter? its the ...
evo 1 my evo1 wont idle had problems with battery had to jumb start a few times got new batttery now wont idle car run ok but when i stop it cuts out got told to take battery off for at least a hour ...
...the diff or do they need to be taken out ? hopefully you can help as the diff is just hanging there 1 out often does it but yes, you have to pull one clear of the pumpkin by about 2 inches. Sometimes ...
...tho i have gotten an E 4 code where the car ran fine. It means: Error 4 Pump cell circuit open 1. Damaged sensor cable or sensor connector not fully seated 2. Sensor heater calibration incorrect ...
my evo 1 rs keeps blowing my td05 turbo, i replaced it and within 10 minutes it blew the new 1. there is white powder in the dump pipe which suggests its running to lean any ideas? Are you priming the
My sons evo 1 will start an idle fine but when you driveaway an engage the clutch to change up to 2nd gear the engine dies.It rev appears to rev fine while in neutal could be your clutch master ...
what can cause excesive wear in tie rod ends many thins. 1 hitting curbs or potholes . 2 soft/bad tires . 3 bad ball joints .4 bad cv joints . 5 worn struts/shocks . 6 bad/poor front end alignment
57 questions posted
Usually answered in minutes!
34 Questions
10 Questions
1 Questions
17 Questions