2000 BMW 3 Series "hex converter" Questions

...the tensioner screws into the left side of the timing cover about half way up. You will see the hex head

...dash board to replace burnt light bulbs 1988 bmw 3251 convertible remove steering wheel (17mm hex nut) remove screws from dash cluster(3 on bottom. 2 on top) Unplug connections to cluster Tilt ...

...manually pushed to near-closure, emergency latching of the top is possible by using the S-shaped hex key provided in the emergency tool kit(attached to the trunk lid underside). First, remove the ...

...sensor located on my 2011 6.7 f350 A 13/16 hex plug with a wire harness plugged into it just below passenger side exhaust manifold or just ahead of the catalytic converter on the exhaust

The Cat. Converter or just below the Exhaust Manifold.....It looks like a Spark Plug with a 14 Ga. wire coming out of it with a connector that can be unplugged for removal.....Maybe 13/16th hex.......

...bmw Release both motors, remove the plastic cover located in the middle of the top inside. Put a hex bit in your cordless drill and unscrew in reverse until the top latches are released from the ...

...converter and / or on the exhaust manifold. I use a vice grip to grab the hex head whereas a special wrench is needed. When loosening, do not turn off but tighten and loosen rapidly, back and forth ...

39;s a 1/4 inch hole so be sure you have lots of time cause it takes forever to drain.The plug is a hex (allen wrench) flush with converter ajasent to the rear end.Like pointing at the back of the car

...motor had been replaced 3 times within 40,000 miles I converted it to manual. I welded a piece of hex stock to the center of the motor. The ratchet handle folds into the panel to lock the window. ...

...of the window, you can see the device that should pull it down tight. In an emergency, there is a hex key in the right side of the trunk that you can use to manually bring that down tight. Your ...