2002 Buick Regal "wipers delay time" Questions

2002 Buick Regal wiper motor parks wrong on dlay 2002 Buick Regal wiper motor parks wrong on delay /pulse mode remove cowling under hood to expose wiper motor linkage. You have to try it many times ...

...stays in delay all the time the wipers are in delay all the time with the wiper switch off or on just have to turn on the key. it is either the multifunction switch (wiper switch) or the wiper

windshield wipers don't work all the time. some times won't start other times won't stop. Is it the switch? it's the wiper delay on wiper motor the cover is the module evey current goes by delay ...

...wipers in delay cycle is normal. You can twist the nob on the end of the arm to speed up or slow down the hesitation. If you are driving in a light mist and the wipers ran at normal speed most of the ...

delay wipers on. The next morning I started my truck to warm it up and the delay wipers were on. Now, my wipers will only work on high. Any ideas? Chevy has had Problems with the Wiper Motors on these

...windscreen wipers?. If so a censer causes the wipers to operate when it starts to rain. the delay controls the speed of the wipers . The drivers manual will explain all the functions if you read

...wipers stay on delay all the time. My wife hit a tree, and now the windsheild wipers stay on delay all the time. The switch doesn't work when turned on. The wipers will work while holding the washers ...

...delay. The wipers will swipe once, and then stop but pop up about one inch as if to go again. Sometimes the wipers when in delay will swipe two to four times before shutting off. The low , and high ...

wipers delay wont work properly. turn them on and the wiper just keep going at normal speed with no delay. turn them off and the keep running then stop in the middle of windshield. The wiper module is

...wipers on any delay position, you should be reading .0005 Amps and 12 Volts and at the same time on the delay position one click below low(the fastest delay speed) you should be reading .0003Amps and ...