2008 Pontiac Grand Prix "removing tail light assembly" Questions

...tail light. 2) Remove the piece of plastic just inside the trunk where the latch is. 3)Then remove the two thumb screws that the cargo net is attached to and the piece can be pulled up. 4)Them pull ...

There may be a piece of plastic or fabric behind the tail light assembly that can be emoved. Then usually the bulb and cable pugged into it are turned counter clockwise about a 1/2 turn to remove them

...TAIL LIGHT Assembly and Look for Anything Out of Ordinary with Wires such as Corrosion Anywhere Clean and REPLACE Section of wire if Nessesary. On GM Vehicles there Is A GROUND WIRE SCREWED or BOLTED ...

...tail lamp assembly to the vehicle. Tail lamp assembly removal Rotate the bulb sockets 1/4turn counter-clockwise in order to remove the bulb sockets from the tail lamp assembly. Remove the bulbs from ...

...tail light bulb? to replace the GM tail light bulb, you will drop down the tail gate and you will notice 2 screws on the tail light assembly, you will remove those 2 screws with the proper screw ...

...tail light assembly 4) Remove tail light assembly by pulling outward, careful not to break plastic guide/nub 5) Disconnect wiring connectors 6) Remove plastic housing access plate on back of tail ...

...tail light assembly on 2003 jeep grand cherokee. There's one screw behind the rear quarter panel to complete the removal process of the tail light assembly. How do I remove that panel? There is 2 ...

...tail light assembly you will find two screws. Remove the two screws. Now grasp the plastic tail light assembly firmly, and pull it strongly backwards. It is held in place with three spring-loaded ...

...tail light on my 2000 Buick Century... looked elsewhere on the 'web and found instructions were incomplete and/or incomprehensible. YOURS WERE PERFECT. Off to get my inspection sticker, now! Thanks ...

...tail light asembly out from the back and you will find the tail light bulb sockets. release the little latch/lock clips while turning the socket assembly about 1/4 turn counter clockwise and you can ...