Question about Pontiac G6
...remove drive side door panel there are screws you have to remove. make sure you've found and removed all of them. then the door is held in with clips from the back side. work a pry bar or a long ...
...drive bolts. Remove the front door window glass regulator track and the front window regulator electric drive (23394) as an assembly through the opening in the front door (20124) . Installation ...
...Remove the motor retaining screws using Torx® drive bit set D79P?2100?T or equivalent, and separate the motor from the bracket and cable drum housing. Remove the motor from inside the door. To ...
...remove the 2. philip head screws. 3. run hand along bottom edge of door panel to ensure no other securing screws. 4. starting at the top rear edge of the door panel side a large flat screw drive/door ...
...drive on one end and remove 5. remove door light at base of the door with a flat tip screw drive. 6. There is also a cross tip screw in side the vent access to the side view mirror on the door that ...
...remove these then use a wide flat head screw drive place this between the panel and the door and pry out this should release snaps or Christmas tree snaps located around the entire door panel work ...
Question about Pontiac G6
...to remove the drivers side panel of a 2007 Buick Allure in order to replace the drives side handle look on Youtube for the How To remove a inside door panel they have lots and maybe your for your
side, disconnect the power mirror switch connector (E). Pry out the cap (F), and remove the screw (G). Release the clips that hold the door panel (A) with a commercially available trim pad remover (B)
...side it will remove easy . two bolt in side with screw drive .then remove small cove( side mirror handle cove ) near door opener . small bolt inside .then 3 bolt under the panel the force the clips ...
383 questions posted
Usually answered in minutes!
1,332 Questions
423 Questions
284 Questions
172 Questions
174 Questions