Frigidaire FEF352 Electric Kitchen Range "clear stove timer" Questions

...Stove is Kenmore drop in range approximatley 15 years old , number on the door 3263B1016P001 Pls advise. many thanks, Pam Oven control beeps and Electronic control as detected fault condition. Press ...

stove. Thanks Hello JJ, Try pressing the "Clear/OFF" button to stop the self cleaning cycle. It will take up to an hour before the oven will unlock the door, if the oven has started to heat up for the

...unplugin the stove and waited about ten seconds before re-conecting once up the top door unlocked cleared the f9-2 error by pressing Auto set button and number 9 for Defauts. Perhaps this can help ...

...clear the dr lo message. If this message comes on as soon as you plug the stove in or just after you push the Off/Cancell pad or after you push start or bake try to push Drawer Off. If this does not ...

...stove/oven on Christmas day(it had been on for over 6 hours) I received an F1 displayed where the temp/timer/clock normally appears. I hit clear off button and it sent away. I have not tried my oven ...

...clear the PF errors at each of the four burners and each stove top burner operates normally including the displays. However, I can't clear the PF, set the clock, turn on the oven or do anything with ...

...stove, and i have no manual. there might be three buttons under the clock One button is for timer, one for stovetop preset and the other for oven preset.Press the second button for setting the clock. ...

i press clear it goes off but still will not let me cook in my oven. gas down draft stove model jds9860aap You need to replace the whole touchpad/display unit, which includes the whole top/front cover

...TIMER) has likely failed in this instance - BUT... Sometimes when you disconnect power to a range and reconnect it the electronic range control gets confused. You should disconnect power again for 15 ...

...stove. Set the timer for 1 hour. 20 minutes later it starts to beep and when I try to turn the timer off it starts to flash "F1". I was unable to get the timer panel working properly and cannot use ...