not presently shorted to ground, your next diagnostic would be to to test the timer connections per the schematic lookiong for a fused contact that energizes the heater, while set to air fluff setting
...Diagnostic test shows code 06 Press the start button and the beeper sounds once and you hear a relay trip but nothing happens. Did a diagnostic / keypad tes and the code was 06 troubleshoot whirlpool ...
...Diagnostic Test or any cycle. -Door switch open while door is locked. 1. Push the door and check if it is completely closed. 2. Verify CCU operation by running a Diagnostic Test or any cycle. Thanks ...
...DIAGNOSTIC TEST The washer must be empty and the control must be in theOFF state before pressing the touch-pad sequence to start the test. Starting the Test Mode â? Close the door. ...
...Diagnostic test and E2 appears, then it tells me to replace the machine control electronics. That seems alittle much, is there something I can check first? The tech at the appliance parts store said ...
Dryer run but does not heat Diagnostic test shows all lights on but the heavy duty light Chedk your breakers the dryer will run on 110v but wont heat
Question about Whirlpool Dryers
...not a good model number GGW900wli send model number again,don'tt know what that code is in diagnostics,what is the problem with the ...
...diagnostic test , said it was the thermistor. We changed that out. Meanwhile, the sensor will kick on the wet button thinking the clothes is wet when it is dry and hot. Even after the thermistor was ...
...Diagnostic test was ok. I have tried jumping the thermal fuse and thermistor no luck. Any ideas or help would be appreciated. 3 Kids make alot of laundry. you may have a bad motor control board they ...
Duet gew9250 - the control lock light is on - and I can't get it off with the End of Cycle button. I can eventually get it to work again by unplugging for a while. But after the next run - I'm usually
64 questions posted
Usually answered in minutes!
1,123 Questions
940 Questions
790 Questions
215 Questions