Logitech MX 600 097855036162 "indicator light working mouse" Questions

light won't go off - New Batteries The change battery indicator came on my Logitech cordless optical mouse. I changed the batteries but the "Red" light and the "change battery" indicators are still on

...for a few seconds then release and see if they sync back up. The red light usually indicates that the mouse is working. It does not necessarily indicate that the mouse's batteries are wearing out.

...indicator light should start blinking. Then within two seconds press the link button on the bottom of the mouse, the indicator light should quit blinking. After re-linking the devices move the mouse ...

...light indicator on the top of the mouse was yellow. We swapped out batteries (new ones tested as good) and the indicator was still yellow and no red light either. We pushed the buttons on the bottom ...

...mouse in use . not green light indicator Red light is showing the activation your mouse sensor. When Sensor activate light automatically on.... i had same problem it was the usb conneter wosnt ...

...that it is on. What shall I do not? 1st make sure your batteries is still working, then PRESS and HOLD the ON/OFF button for few seconds until the mouse light on, then your mouse is alive! YBC

...indicator on the bottom of the mouse isn't lit up. this mouse has worked in the past and when fully functional the light on the bottom would light up and the light on the USB wireless relay would be ...

working. When USb is connected, it dings but there is no light indicating it is connected. The mouse has a new battery. The control panel > Mouse > Properties says the device is working properly

...touchpad is still working but the wireless mouse is not responding. The red light indicator is not also illuminating. Thank you so much for your help. Put a new batt. in it if the red light is also ...

indicator light is on and the senor light is on as well at the bottom of the mouse. I looked under the Mouse Settings in the Control Panel and it says it's working properly. I even tried unpluging the