...squelch control knob on the front of the radio to about 10 o'clock and slowly adjust VR3 until the signal from the speaker is mute. When you turn the squelch back to the 0 position, you should have ...
Help setting up bc145xl scanning radio you have to adjust the squelch. When it scans it will stop when ever the squelch breaks. Start with the squelch turned up a little less then half way, then scan.
Question about Maxon Radio Communications
...radio,,the squelch is not working in any direction, help. i think someone has messed with the squelch pot where is it Robin, Check the attached links,instruction and guides, Good luck "I hope this ...
Question about Maxon Radio Communications
pot, circuit needed. [email protected] Well my friend I have same problem with some radio. Maybe you should try just to connect detector to audio amplifier and than make an squelch circuit in AF
...squelch. How do I go about it? The other radio is fine. Thank you for your time. Massimo Turn the squelch control clockwise just enough to cut the background noise, this should work well for ...
Question about Radio Communications
...squelch setting is set too low. This will stop scanning, and as the radio thinks there is a valid signal, it will not transmit. I have no idea what radio you are using, but this is a common situation ...
...squelch control is not working ( I get lots of static) radio still works. Sends and receives, but when I turn the squelch control it makes no differance. what time of day are we talking here? usually ...
...can hear sound when first turned on,but no sound when adjusting squelch turn squelch all the way to left and leave it there RF gain should be all the way to the right.Radio should be in CB not Pa ...
Question about Cobra Radio Communications
...knob to get the dss right, there is no noise for the squelch at all. I think its vr6 in that radio but you have to turn it till you hear noise. did you use a signal generator to set the
...squelch my radio at all, even adjusting VR4 does not allow me to squelch it. You may have a bad transistor or detector diode that feeds the squelch circuit.If you can read a volt meter and Ohm Meter, ...
226 questions posted
Usually answered in minutes!
39 Questions
8 Questions