...opener try to align it with the emisor sensor...check wires ASSUMING THEY ARE AIMED CORRECTELY-- YOU MAY HAVE A BROKEN WIRE TO THE SAFETY EYE OR A BAD SAFETY EYE. TRY RUNNING A TEMPORARY WIRE DIRECT ...
Question about Sears LiftMaster Building Materials
...opener when i tried to use the remote it opens but when i tried to close it, it goes halfway down and then it goes back up but when i use the keypad on the wall it works find Realign safety eyes. A ...
opener did the same thing once before so I was operating the door manually. Then one day after sweeping the garage floor, I tried it...on a whim... and it worked. I thought maybe the broom has hit the
...to hold the enter key or wall button until the door closes. By holding down the wall button you are bypassing the photo sensing safety eyes. Look at them at the bottom of the track. Both should have ...
...opener will work a couple of times and then stop working. The yellow light on the back flashes constantly. Any suggestions or advice motor is over heated shut down unplug 30 min Does it simply click ...
...opener wall remote and jumped across the terminals to bypass the remote switch and eliminate a possible defective remote button with no change in condition. Is this a possible circuit board defect? I ...
...bypass my sensors on my garage door opener? I have no kids btw.. and the wires are broke off at the connectors on each sensor eye. I've tried to fix them but would like to jumper out the terminals at ...
5,971 questions posted
Usually answered in minutes!
0 Questions