line,do i need to reset the guide. The guide is called a fence. The fence should be positioned to the right of the blade. When using the fence, the largest part of the board goes between the blade and
...line up the blade with the fence Hi there, I take the blade out of my tri square and lay it between the fence and the blade and let it touch the blade. Then I set the fence tight with the tri square ...
...line up with table rotated 1/2 degree to the left. How do I reset the Zero detent for a 90 degree cut? Undid the RH fence-bolt in the table behind the fence and tapped the end of the fence forward to ...
fence to line up with blade.i tried everything that was in the trouble shooting guide. I am guessing it must be damaged beyond the adjustments. Are you sure the blade is aligned with the table? If not
...line up with the rip fence .When I try to line them up, I"m about an 1/8 of an inch off from the back of the blade to the front. I don't see any means for adjusting as the motor is fastened solid to ...
fence you are using is not on a true parallel line with the blade and as a result it is causing the wood to pull into the blade causing kickback. I would do an alignment procedure on the fence to make
...line of fence/table and other leg against blade and inclined 45 to both table and fence. Make sure all three are dead square. I never found any way to compensate for the play in the blade itself. It ...
...and it cuts about 1/16th to the left. when you aline the fence to compensate for that it puts the motor in a bind. How do I line up the blade?? Use a washer as a shim on the shaft for the
...line it up properly, it should work. Just make sure the CENTER if the blade is lined ip with the center of the blade guard mount. Use folded paper to match the kerf on one side of the blade and use ...
...line rip blade. It produces unacceptable cuts also. The blade is square to the table and the fence. You can see and hear the blade vibrate part way through the cut leaving a very wide kerf in various ...
63 questions posted
Usually answered in minutes!
40 Questions
32 Questions
33 Questions