...lines like if my blade was dirty. I make sure my blades are clean and when I switched clippers.. I had no issue with lines. Sounds like it's time to replace the clippers with something much
clipper blade may need to be thoroughly cleaned. If the blade is clean and well lubricated but still not moving you may have blown the motor. However, if the blade is moving freely when turned on, and
Blade won't snap back on I went to clean the hair inside the clipper and now I can't get the blade to stay on. make sure the clipper is running when you try to snap the blade on.
...clean If you can pull the blade away from the clipper without pressing the blade release button then either the hook on the Latch is broken (which will mean all blades have the same problem) or the ...
Question about Andis Pets - Others
...BUT HAVE NOW GOTTEN LOUDER AND LOUDER WITH MULTIPLE USES. It might just be your blade needs a good clean up sharpen and
...clipper set called Endurance clippers last year. This year I tried to clip my minis for spring and the clippers would only cut for about half a swipe then they only pulled the hair. I took them off ...
...clipper over heating Run for about 10 min then get hot to handle Either your blades need cleaning and oiling or it's possibly a faulty armature without testing the clippers and part mentioned with a ...
Question about Wahl Pets - Others
...whats wrong with them? its when the comb is on it and I have to stop all the time and clean it out If they haven't been sharpened recently then this is a good place to start. Clipper Blade ...
...clean and now did help putting them back together Do you have more parts in your hand than 2x screws and 2x blade parts? If no then pop the small cutter blade onto the plastic blade drive with the ...
...clipper's power to just before it gets really loud using the side adjuster, but when I start cutting the moving blade gets progressively slower until it barely cuts or even stops moving all ...
1 questions posted
Usually answered in minutes!
2 Questions