Question about Kenmore Dryers
...thermistor shorted fault on my Kenmore HE5 dryer and no heat. Replaced that part and the thermal cut-off. Still have the same fault and no heat. Ideas? If you replaced the thermistor and still have ...
Question about Maytag Dryers
...run, fault code is a symbol that looks like an upside down F 5 beeps while displaying code... I have replaced the THERMOSTAT & THERMISTOR and still get the fault code ! please clarify on the ...
...fault code E1 means the electronic control detected the thermistor is open. It's either the wire harness connecting the thermistor and electronic control is broken or the connection is loose or the ...
...fault code E1 means the electronic control detected the thermistor is open. It's either the wire harness connecting the thermistor and electronic control is broken or the connection is loose or the ...
Question about Asko Dryers
...Thermistor fault - Open thermistor, replace - Bad wiring to thermistor F4 Too much lint in the lint filter, front housing, or in the condenser Clean lint from lint filter and/or condenser F5 Fault in ...
thermistor fault if the lint filter including the vent system are all clear from lint built up but the AF code persists. Disconnect power then remove the rear access panel and locate the thermistor on
...fault. Remove the back of the machine and try to locate the air duct going from the blower to the drum. Normally inside the air duct you will find the heating coil and the thermostats/thermistor. You ...
...Thermistor fault 1. Open thermistor, replace 2. Bad wiring to thermistor F4 Too much lint in the lint filter, front housing, or in the condenser.1. Clean lint from lint filter and/or condenser F5 ...
...fault When run on any heat setting the machine goes to F13 after about 30 seconds. I assume the cause is one of the Thermistors but I'm unsure which one is the culprit. My question is, should the ...
1,774 questions posted
Usually answered in minutes!
1,329 Questions
750 Questions
524 Questions
182 Questions
177 Questions