...advance timer motor until it closes again for heat and this continues till clothes are dry]so as long as timer is receiving that voltage and not advancing then i agree its the timer.other wise it ...
timer to advance. If the motor is faulty, the timer won't advance. You can use a multimeter to test the motor for continuity. If it doesn't have continuity, you'll need to replace the motor. Check the
Question about Dryers
...timer won't advance on auto setting, will advance on timed(high heat), but won't heat or shut off. Air timed, will advance and shut off. Trap clean,hose clear, reset breaker. I suspect you have a ...
...timer doesnt advance. my dryer heats great and everything works great, only thing is the timer never advances, it will run forever if you do not cut it off. If the timer does not advance even on the ...
...timer will not advance in either time or automatic cycles, you will need to change the timer. If the timer advances in time cycle but not the auto cycle, you need to make sure it is heating properly. ...
...connection failure in the orange wire from the heating element to the timer. If the timer will not advance in either type of cycle, then I recommend checking the timer part number that you are
...timer doesn't always advance. It can work for days and then stop advancing for days but I do get heat when it sticks but no reverse action. Where do you suggest to start looking. Thank you for your ...
...advance. the timer will not advance without heat.the dryer heats up when it reaches temp. the heat shuts off and the timer advances,when the heat comes back on the timer stops,send the model number ...
Question about Maytag Dryers
...Timer does advance just fine on air fluff cycle. Cycling thermostat checks out fine with an ohm meter. It also clicks when heated and clicks when cooled of, too, but I'm unable to accurately say at ...
Question about Kenmore Dryers
...advance and shut off It sounds like the timer motor (attached to the back of the timer assembly) is not getting power. Possibly, the timer wiring connector is not making good contact or the timer ...
38 questions posted
Usually answered in minutes!
1,743 Questions
867 Questions
815 Questions
489 Questions
196 Questions