Maytag Neptune MDG5500AW Gas Dryer "burner quites working" Questions

...working alright, and the burner won't light, then consider the gas valve coils. These electrical coils are above the gas valves and when energized, these coils open the gas valves and permit gas flow ...

...working. I pulled the unit, disconnected it (hardwired) and tested the power. It shows 220 (breaker didn't trip after being disconnected). Opened up the glasstop...no obvious burned wires or ...

works for a few minute then shuts off and beeps quite often check the exhaust vents for any lint build up which will shut down the burner electronicly

...fine.Thin belt broke, replaced it ok. Now this????? Model# 97585200 stock # 75852 When started, burner came on, minutes later the flame went out. Tried 3 or more to start, only glow plug did its ...

...counting the igniter) for gas to flow. One is the thermostat witch warms and send a signal that the burner is lit so gas continues to flow. It could be defective giving wrong resistance value to ...

temperature setting and start the dryer. Watch the burner assembly, shortly after starting the dryer the ignitor should begin to glow or spark. If you see it glow or spark, then the ignitor is working

...wouldn't turn. Made sure belt switch was ok. Pressed start switch and watched igniter heat up then burner fired. reassembled unit and slid into location where it will be used. started it again and ...

I have a Kenmore 72602 dryer, my dryer starts fine, but after about a minute the burner turs off and there is no heat, What causes this? is it an easy repair It is an easy repair. The sensor and ...

loud burner dryer after LP coversion I just had a licensed professional convert my new LG gas dryer to LP. When the burner comes on it's quite loud. The guy that did the work said all is OK with ...

...to Do you have any idea what is blowing the thermal cut off Thanks in advance is the flame in the burner tube impinging on the cutoff? This can happen if the burner tip is dirty. The flame can then ...