...the spin cycle applies to washing machine. Check where the water is leaking from. Most likely the drain pump hose is cracked. Need the model number of washing machine to make further
leak at the water supply connection that only stops when you turn the water valve off. If the machine fills and immediately starts leaking water during the wash cycle, it means there is a gravity leak
...think you most likely have a basin Float water level sensor that is no working correctly, the door seal is not water proof, if the water level gets over the lip of the basin it will leak on the
...in the base. Be careful when you take the panel off, the exposed edges are razor sharp. Drain any water in the base, reset and try the machine again and watch for a leak through the inspection
water leak left side bottom @ beginning of washing cycle If this leak only occurs at the beginning of the wash cycle, (and it would happen at every water intake), the problem would be between the ...
...water to 165 deg and cycle the tank heaters off when idle and back on when wash starts. when you start washing the tank temp will slowly drop down to about 120 deg and stay there till idle again. ...
water enters into the washing machine, it leaks from the top the machine. It looks like the water tube that connects into the top and the spining arm that disperses the water on the inside. The seal(?
...of the anti flood system (polysireene float and micro switch at the base of washer) due to water leak / spill (this device causes the washer to stop until the leak is cleared.3) Water pressure to
...water inlet hoses/washers or if it leaks only while washing, have you checked the outlet hose for cracks/pinching after checking these two options you will have to remove covers and investigate for ...
41 questions posted
Usually answered in minutes!
26 Questions
35 Questions
14 Questions
12 Questions
5 Questions