F1 code on fisher&paykel DD603 dishwasher The lid assembly isnt sealing, I can only assume the lid actuators are bad, but how do I test them to make sure its not something else like a problem in the ...
Question about Dishwashers
...DD603 starts both drawers by itself and power button turns off briefly. Then they restart and F1 fault on top drawer. No water in base? The F1 fault means the top drawer was not shut completely or an ...
Question about Fisher and Paykel Dishwashers
...mote to check out how the Lid seal properly or not so you can change either the lid or the actuators. Once you get to the diagnostic mode try to get on the LCD displays LD( or LS) meaning
Question about Fisher and Paykel Dishwashers
...reverse is true when closing it. Any help would be appreciated. Thanks...Jared Sounds like your lid actuators are not opening completely, they move the lid up and down. They are prone to failure, F/P ...
Question about Fisher and Paykel Dishwashers
...likely the lid is stuck in the down, or partially down position. This is usually caused by the lid actuators (motors) not returning the lid to its full up position and therefore the drawer top is ...
Question about Fisher and Paykel Dishwashers
...DD603 two drawer dishwasher Lost power in top drawer of the dishwasher & it was jammed shut, so I dragged it open as the general advice says can be done, but the lid that keeps the water in the ...
Question about Fisher and Paykel Dishwashers
...unit off and wait about 10sec and plug it back on.....that usually does the trick. Sounds like the actuators that pull the lid down are stuck.... nasty
...I fix F1 code is water leaking. 1- Dry out the bottom housing to make the F1 disappear. 2- Replace Actuators and the lid seal to prevent this happens again. The actuators is pulling down from the ...
...dd603 double dish drawer. both lids have been replaced due to a F1 error and bottom actuater motors. the bottom drawer powers up and fills but the lid does not come down. could the mains filter board ...
...DD603 Dishdrawers had leaked overnight with a large puddle on the floor in front of the unit. I diagnosed the cause of the leak (failed bottom drawer actuator), but I am now more concerned that the ...
955 questions posted
Usually answered in minutes!
201 Questions
174 Questions
104 Questions
87 Questions
68 Questions
