2003 Hyundai Elantra GLS "copper pipe sizes" Questions

copper pipe to bridge the pipes, so you will need to cut the ends off and use some jubiees on the pipes to secure it to the copper pipe standard house hold size copper pipe, if you do need to cut ends

copper brake pipe size Brake pipes need replaced - need to know what size of brake piping to buy go into any reptuible car spares place with car detailes they will be made for you within an hour dont ...

pipe or copper. sharkbite is the easiest way to go,you just push them together. home depo or lowes carry both do you mean you will sweat two new copper lines in? if so this would be the correct way of

...there a way to replace this rubber hose section without having to replace the whole line? I've done it using the appropriate size piece of copper pipe stuck in the hose and use clamps on either

...the engine compartment. you will have to join them together so that everything on the engine still works. they are usually 20mm or 3/4". you can use a bit of copper pipe that size and the hose

...copper tubing, you should flare the ends to insure a good seal. Yes, look at the center of the firewall behind the engine, locate both heater hoses, you can disconnect them at the firewall and put a ...

...Bravo 1.9 multijet diesel with manual transmission? Is that a 10 mm bolt of about 50 mm long with a copper washer behind the head? Cheers. filler plugs are normally located about 1/2 way up the side ...

...copper pipe between them. The hoses are different sizes so you need to use strap screw clamps to tighten it up.(I hate the spring steel ones they use anyhow...any time you work on the cooling system ...

...pipe by the turbo & grab the copper washers & loosen the coolant pipe bolt STEP 17 Remove the coolant return pipe from the cylinder head & pressure sensor bracket. Once again, Grab the copper washers ...

...copper pipe and a couple heater hose clamps. Or, remove the hose that goes from the water pump to the firewall completely, then remove the firewall end of the other hose and connect it ...