HP ProCurve 2626 (J4900B) 24x10/100 Mbps Networking Switch "port set" Questions

...set speed limits on ports, etc... A normal switch is "dumb", there is nothing to configure and it just does it's thing, connecting anybody and everybody that are connected to any of it's ports. ...

...port is off. Now if I haven't lost you yet. Both the ports are configured the same and they are on the same VLAN. They are both set to the same speed everything should be working but it doesn't. If ...

I want reset the factory default of my switch HP Procurve 2510G To reset using the CLI, run the command "erase startup-config". When prompted, say yes to reboot and that will restore the procurve ...

...default state by following these steps: Remove the power cord from the back of the switch. Connect port 1 to port 2 on the front panel, using a standard network cable. Reconnect the power cord to

...power is in use on this switch? it might be using too much, or the PoE might be faulty. Contact support by calling ...

...set up a network: Windows Server 2003 (Dell PowerEdge sc1425) and 40 pc's all connected via 3 ProCurve 2626 Switches, however they are all second hand and have NO manuals or instructions or cables, ...

connection error ALL CONNECTION LOOKS GOOD BUT THE NET WORK IS NOT FUNCTIONAL can you clarify the switch configuration, by default it will have all ports as untagged in the default vlan 1 with a bootp

...port. I quote from the installation guide: "In the factory default configuration, the default IP (Internet Protocol) address of the switch is 192.168.2.10 and the subnet mask is 255.255.255.0" So set ...

...then the port at the other end must also be set manually...to the same speed and duplex values. If one port is set to auto, then the port at the other end of the cable must also be set to

fault light is on, all else looks normal and chassis fault light is on, all else looks normal and green. u can change the settings in bios to light off the chasis fault light. restart your system then