Ricoh Aficio CL2000N Laser Printer "paper lever" Questions

...lever. When the paper tray is loaded and place back into the machine a "paper present sensor" is actuated and sends a signal back to the machines logic. If this sensor is broken or missing, it never ...

...of paper in half and using the blue lever inside right side door feed paper between feed rollers. Make sure you do the whole width of feed section. There might be a small piece stuck you can't

...remove paper fully--- under the printer move lever to the right and remove the feed roller(do not turn the printer upsidedown) transfer roller -- front door--- press 2 green locks and pull unit ...

paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor

...paper feed trays and their settings for an hour before I figured out they meant OUTPUT. Check and remove any prints from the output tray, that is where the prints exit. Check if the exit sensor/lever ...

Sketchy printing along left margin of paper Print is crisp and clear on right side (3/4) of paper, but the entire length of the left side is "sketchy" (light ink coverage). There are no Maintenance ...

Remove Misfeed B Fusing Unit Error- After 1 page is printed We are getting this paper jam error Remove Misfeed B Fusing Unit, but I can't actually find anything jammed. Sometimes I am able to reset, ...

...and am still having this problem. Check that the fuser is reaching the right temperature, Is the paper coming out warm? Is the toner loose on the paper? To check the fuser: Switch off the device, ...

...lever lock on the toner hopper. The replacement went fine...the little teeth are extending fully into the toner bottle when the handle is up and retracting fully when the handle is down. I put in a ...

We have an SC548 code on our Ricoh3500 "Fuser not installed error code". Did you have a paper jam in the machine? If so open the right door and make sure that the fuser unit is correctly set. You have