Question about Datacard Office Equipment & Supplies
...to brake or the broken ribbon it self? 1. check edge to edge settings in printer toolbox 2. to fix broken ribbon re wrap it straight over the take up spool and use a piece of tape to hold
...ribbon mis-cue" How do I fix this? Any advise? When you have a ribbon mis-cue, first remove the ribbon. Go to the printer driver, printing preferences, calibrate, sensors. Click sesors then send... ...
...fix problems while the printer power is on. ?If the print ribbon is stuck to the card, the Intensity setting might be so high that printing causes the ribbon to stick to the card. Lower the Intensity ...
Question about Datacard Group Office Equipment & Supplies
...* If the ribbon was repaired, the wrong take-up spool was used. Repair the ribbon again, using the correct take-up spool. If you cannot fix the problem contact your service provider for assistance. ...
...out of the way of the ribbon sensor (3) reload the label and ribbon. The printer will run a number of labels out. See if this helps you fix that ribbon out error. Zebra 105SL Ribbon Out Error ...
Question about Zebra Office Equipment & Supplies
...Appears on the LCD " error no ribbon installed " but the ribbon is new in the printer , "info msg invalid ribbon error " after print tast image from menu the printer .can you help me how can i fix
Question about Epson Office Equipment & Supplies
fix it??? when printing, the ribbon always comes out from the slot... what is the cause and how to fix it?? 1-when install your ribbon push it to fit its proper place, 2-make a proper distance between
Question about Zebra Office Equipment & Supplies
...ribbon there, how do I fix this? Recalibrate the printer, Verify that you upper media guide(snap plate) is installed in the machine. Then replace your ribbon sensor. Snap plate MRP provides IT Parts ...
on display panel. Remove the ribbon along with its fitting from the printer and fix it back. Replace the ribbon, if in case worn out or used excessively or stuck within. I hope this fixes your problem
...fix it? I assume you are using YMCKO ribbon rather that K monochrome. If using YMCKO (or a few other specialist ribbons) the spool has a large blue collar at the back with a paper covered chip. The ...
264 questions posted
Usually answered in minutes!
402 Questions
235 Questions
259 Questions
211 Questions
166 Questions