2011 Harley Davidson FLHR Road King "remove back rest" Questions

Remove the back rest bar. 4 Drill two holes into the seat pan at the marked locations, using an electric drill and a 9/32-inch drill bit. Place the back rest bar onto the seat pan. Screw the kit's

remove the back rest held on by two cap nuts, that will allow you to remove the small back seat. Once the small back seat bolt is off you lift the back and pull backwards to remove it. Now you can get

...remove the axle bolt, knock out the spacer, and slide the brake panel out of the way. Now the wheel is resting only on a splined shaft. Grab the wheel and gently slide it away from the final drive ( ...

install help driver seat back remove seat the back rest mount will bolt to fender w rear passinger grabrail mounts 1/2 in nuts 2 of them,, mount there..

...remove the seats take off the back rest. Unlock the tool pouch storage and remove the tools and lift up the rubber spacer on the bottom. You'll find a phillips head screw. Remove the screw by ...

...remove the back rest and sissy bar off the back of my 01 suzuki intruder vs800 the manual wasnt much help and havent found anything on the web about it May I suggest a trip to your local library. ...

...remove the single bolt that holds the rear of the gas tank down. From that point, slide the tank back and off of the two rubber bushings that the front of the tank is resting on. Disconnect the fuel ...

back To replace the 2011 Touring jiffy stand leg FIRST support the motorcycle with a suitable lifting device so it securely upright and level and the jiffy stand is able to move through its full range

...thread out? After you remove the weight try putting the screw back in a few threads ang get hold of the screw head with pliers and try to pull out the rest of the weights,hope this helps has for