Philips 55PP9401 55" Rear Projection Television "testing pico fuse multimeter" Questions

...pico fuse is bad on my circut board This can be tested with multimeter only, set multimeter on continuity and check pico fuse both pins, if meter shows zero ohms resistance that means pico fuse is ...

...pico fuse" to determine what you need. Make sure you re-solder the ends you removed from the board. If this doesn't work and you still have the problem, your next option is to replace the convergence ...

...testing/replacing two small pico fuses. The replacement ICs for your set are part number: STKxxx-xxx and are available from www.encompassparts.com for $19.95 each (needs two). You will also need at ...

...fuse one by one and plugged in the tv but that was no help. I am going to test the fuses tomorrow with a multimeter. Is there anything else I can test? Any suggestions on what to do next? Any help ...

...pico fuses you're merely testing for continuity. If you get an infinate reading you're in good shape - if it doesn't budge the meter the fuse is open... That's a really easy set to work on for ...

...Pico fuse part number is as follows:1-533-595-31 IC LINK 3.15A 90V Also need to check any burnt or faded-color 1 or 2 watt resistors on D board. STK392-560 part is correct and it has been marked on ...

pico fuses and replace if necessary, as well as the 3.9 ohm resistors out in front of the amps.After alll the repairs just re-install and you're done - except for some touch-up convergence.NOTE: Don't

...pico fuses. They are on the the circuit board the power goes into. I used a multimeter to test them for continuity. It turned out it was the 5amp one that was bad. I soldered a new one in that I ...

...fuse one by one and plugged in the tv but that was no help. I am going to test the fuses tomorrow with a multimeter. Is there anything else I can test? Any suggestions on what to do next? Any help ...

...pico fuses will have to be tested. for an engineer to do the work it will probably cost £300 to 450 pound, if you were to do it 40 80 pound but you'll need circuit diagram and a good multimeter ...