Toshiba CZ36T31 36" TV "sometimes picture goes thin line" Questions

picture sometimes goes out but comes back just fine later I have a 27 inch Sanyo TV appx 10 yrs old and sometimes now I will lose picture and a line goes across the screen, but I can hear the TV just ...

AND AUDIO CLICKS OFF, 18 MONTHS OLD, YOU THINK THIS IS THE PICTURE TUBE is the bright line on the midle of the tv , if it's what u ia vertical problem also sometimes is the flyback , tv needs service

...picture tube neck id fitted a coil alongwith it, which is called the deflection yoke, and it will have four wire connections. Out of these four wires, two of them will be thick, usually red and blue ...

goes away and then comes back on. When it appears, I get a degraded picture. Also, I have shadowing of the lettering. When I turn off the cable box, I experience a thin vertical line that races across

...picture goes from normal to sometimes having thin black horizontal lines breaking up the picture such that about 75% of the total picture is viewable (it still looks OK, but not normal), other times ...

...picture slowly get to full-sized? Question 2: Should we get it repaired now, or wait until it progressively gets worse? It only happens once each time when we turn the tv on, or a few minutes later, ...

...picture line across the screen. Then in a few minutes, it comes back normal. Sometimes there is a thin line at the bottom of the screen. Should I replace it? Is it too old? sounds like a loos ...

...picture was a couple of inches short". Normally this should be around 100uF connected between pin8 & pin 12 of LA7836; agree that the Vertical IC LA7836 is busted hence the single line; in most ...

...picture up and down.Sometimes the output IC developes loose conections and sometimes the IC just goes bad,if you tap the set on the side lightly and it reacts it might only be a loose conection. If ...

...sometimes the picture would come back or you would get a partial picture. It is a Toshiba model # 36A40. HELLO The problem here sounds like dry joints on or around the field/frame output IC. I have ...